CO2 Incubator, CA-ICB-CO2-260

The CO2 incubator is ideal for the experiments of the cultivation of animal cells, sperm/ovum, anaerobic cells, all sorts of microbe cells, hatching/germinating and special tissues.

Features 

• 6 sides direct heating system

Electric heating wire is covered on all sides of the chamber which makes stable uniformity and provides fast heat-up & temperature recovery. 3 parts of heating section are controlled and calibrated individually by 3 temperature sensors.

• Dry wall and air jacket

Warm air from heating wire is preserved in space between the chamber and the insulation layer. It helps temperature recover faster and minimize heat loss. Dry wall withinsulation requires no regular maintenance.

• Dual beamIR CO₂ sensor

Fast & precise detection for CO₂ gas regardless of temperature and humidity.

• Natural humidification using water tray

The heater on bottom side warms the water in tray and it makes humidification. The circulation fan delivers the moisture formed from the water in the entire chamber.

Advantages

1. Alarm system: Buzzer to alarm low or high deviation of CO2, temperature.
2. Gentle air and moisture convection: Natural air and moisture convection, air and moisture in chamber are distributed gentlely by 6-side heating and air circulation fan.
3. Easy to clean: Rounded corner allows easy cleaning. The entire chamber is made of stainless steel (SUS304).
4. Overheating limit: Heating is automatically cut by safety device when temperature control fails or there is excessive heating over set point.
5. Perforated shelves: Perforated shelves are good for natural air flows and are made of stainless steel which is resistant to rust and contamination.
6. No condensation: Heating by front door heater & frame heater prevents condensation in the chamber and on the glass door.
7. Microprocessor PID control: Intelligence control for CO2 density, temperature, alarm.
8. Access port: 25mm Access Port is available at left side. (Upon ordering and additional charge)
9. UV sterilization: 4W UV is placed on the chamber ceiling and beside the circulation fan. The UV light cannot reach sample and sterilization is operated during culturing.
10. Maximum 125℃ dry hot air sterilization. No need to remove IR CO2 sensor.
11. Monitoring system: Analog connection port has been designed to observe the status of equipment in real time even in the far distance.
12. Lower gas consumption. Lower heat loss. Faster recovery easy classification for various samples.